"The Mulberry" 

Introducing "The Mulberry" our XL diamond barrel piece with a difference. 

The Mulberry in Medium grit is our larger Pedi pieces that will quickly reduce calluses and hardened areas of the foot quickly due to its size. Its not just its volume that new, it has a cut out design to avoid clogging, lets the dust pass through and to avoid heat.

The most comfortable way to reduce calluses for your client & for you as the tech!

Remember its not about a blade, NO cutting involved just exfoliation!

• Speciality Diamond Bit 
• Medium Grade 
• Perfect for working on larger problem areas of the skin, reducing calluses
• For left handed & right handed use 
• Shaft width 3/32" 
• Fits all E-file machines 
• You must never fully remove hard skin. Always leave 10% behind.
• Used on its own, with "Willow Spray & Go" or in conjunction with a Callus remover.
• Using a callus reducing product will reduce the hard skin quicker and will help avoid generating heat.
• Lasts for 2-3 months
• When cleaning be sure to clean inside the cavity of the bit
• Key way to know when you need a new bit is it will start to generate warmth.

Dimensions

Head height: 21mm
Shaft height: 43mm
Head diameter: 34mm

The Willow range is compiled of our best pieces to make your job more effective, cost efficient and easier on your body as well as your pocket. 

The bit must be cleaned periodically to remain sharp by following the manufacturer's instructions. Drill bits usually last 2-3 months but this can vary dependent on how busy you are. 

AFTERCARE & CLEANING: 

• Use warm soapy water, our Spit-Spot-Bit-Pot and our Willow Brass Brush to remove the dust and product debris from within the grits, flutes and teeth. 
• Do not allow the bit to air dry!
• Once the bit is fully clean and dry you can use your preferred sterilising method. 
• We recommend our "Willow Spray & Go" system as the less time your bits spend immersed in solution, the better!
• Lay your E-file bits on a towel and evenly spray the Spray & Go over all of the bits.
• Roll the bits over and spray evenly again.
• If soaking in barbicide please only steep for the recommended time, over-steeping can dull your drill bits.
• Wait 2 mins and then dry all of your bits thoroughly by hand (do not leave to  air dry)
• Store in your bit case or bit book.